ECOLIFT – HYDRAULIC PUMPING UNIT

  • Delivered using a 5 tons-9 meters long bed cargo crane mounted on the delivery vehicle or Foco truck ( 2 units HPU per truck ) to the wellsite.
  • Installed in less than 4 hours using the same Foco Truck.
  • Economically transferred from well to well for production testing and replacing conventional pumping unit in service period or long idle due to major repair (minimized down time).
  • Maintenance and operation time
  • Installation time ( no foundation preparation required )
  • Easy to dismantle for work over preparation and reinstall after work over with 15 -30 minutes to put the well back on production.
  • Does not clutter up the landscape
  • No big weight swinging around and moving parts are fully shielded
  • Eliminate stuffing box leak due to align polished
  • Low noise level power pack < 40db
  • Consume 25%-75% less power
  • Using 2 size electric motor to covered mid and deep wells (20 HP for mid depth wells and 40 HP for deep wells)
  • Using 2 size electrical generator only (diesel or gas engine) to covered mid depth (30 kVA) and deep wells (60 kVA).
  • 25% -50% fuel saving compared to conventional Pumping Unit or conventional HPU.
GENERAL SPECIFICATION

Stroke Length : 50 to 120 Inches ( 168” – 240” SL avail upon request )
Stroke per minutes : 2 to 10 spm
Pulling Capacity : 15.000 to 30.000 lbs or 50.000 lbs  peak polished rod load  (PPRL)

Prime Mover
  • Natural gas engine, electric motor, diesel engine
  • Enclosed or open power unit
OPTIMIZATION EQUIPMENT
  • Load Cell Capacity – 30.000lbs or 50.000 lbs
  • Position Transducer Dual PositionSwitch,Accelerometer type
  • Expandable I/O – 4 Analog & 4Digital
  • VSD Interfacing Card
  • GSM Module – GPRS Data Transmission using MPLS or VPN

Features:

  1. Surface Dyno & Down hole card using Everrit & Jennings Method or Gibbs
  2. SV & TV Test Capability
  3. Run Time Log for 90 days
  4. Inferred Production log for 90 days
  5. Alarm message (Over/Under Load, Low Load Span etc…)
  • Capacity 20 &  40 Hp
  • VSD Type Flux Vector

Features : Automatic Load Control ( ALC ), Communication Interface with RPC

  • Well Head Monitoring – Tubing Pressure & TempTransducer
  • Hydraulic Power Pack Monitoring – Hydraulic Pressure & Temperature Monitoring
  • Dynamometer Data such as Dyno Card, Pump Fillage, SL and SPM
  • HPU Operating Status : On/Off, Run Time, Theoretical Production
  • Wellhead Pressure and Temperature Data
  • Mobile Surveillance Daily Monitoring using Notebook or IPAD SMS Alarm Message and Alert System via Phone Cell.
  • Email Daily Reporting for:
    1. Daily Status(On/Off)
    2. Daily Parameter Report ( SL/ SPM, Run Time, etc..)
    3. Today & Yesterday Fluid Displacement
    4. Well Head Pressure & Temperature Data